Keeping Your Battery Clean To Always Be Safe



Have you ever attempted to jump start your car battery and was dismayed that it was covered in gunk? That particular gunk that goes all over the battery is corrosion formed by acid condensation. You can easily clean this by using a simple chemical solution. If you have baking soda around the house, then you're going to be able to remove the battery acid. You should be mindful when doing it but there are just a couple instructions on how to clean your battery.

The first thing you must do is to get the necessary supplies, which you may already have at home. You principally need safety glasses covering your eyes, baking soda, adaptable pliers and screwdrivers with insulated handles and a stiff-bristled brush. Other things you need consists of a metal or plastic scraper, box or open-end wrenches, cleaning brushes for the battery terminal, and either a turkey baster or small funnel. Several sponges or clean cloths, a spray bottle with all-purpose household cleaner, some rubber gloves and a large container of clean water. This all will guarantee a safe cleaning of your battery.

Since the corroding deposits contain sulfuric acid, it is best to use rubber gloves and the safety glasses. It is advisable to continue to keep this compound away from your car, because it can eat away the paint. Exactly how much you must clean the battery is determined by how much corrosion it has. It is possible, to get all the dirt and corrosion off of the battery, that the battery will need to be taken off the vehicle. The initial step is to use the scraper to remove as much dirt as possible and use the bristle brush to get at more.

The next phase is usually to make a mixture of one tablespoon of baking soda to a pint of water, and take the turkey baster, and carefully apply the solution to the outside of the battery, along with the cable connections. You then work with the brush to remove the surplus deposits plus be sure to disconnect the cables for easier cleaning. It is possible to take away the cables, starting with negative first then positive, using the pliers and wrenches. Brush away much of the oxidation from the terminals and all of the parts, and then flush each one with the baking soda solution.

You can More Bonuses use the spray cleaner and sponge to get rid of any additional dirt and grease. Immediately after, dry every one of the parts and reassemble everything and be sure you hook up the cable with positive first. Lastly, be sure that everything is attached and now you have a clean and safe battery.

Leave a Reply

Your email address will not be published. Required fields are marked *